GÖLZ FS 170 - Installation and Operation; Water Supply and Cutting Operation

16
FS 130 /FS170
2
1
3
Danger: Do not use the attached water tank when cutting with wet cutting
diamond blades. The segments may crack off and cause injuries to the ope-
rator or bystanders!
Water supply
Cutting with wet-cutting blades:
Connect the water supply to the GEKA-coupler (1) of the fl oor saw. Check the ball valve (2) is closed (ball
valve lever in 90°-position to the water fl ow). For cutting open the ball valve (2) (ball valve lever in the water
fl ow position).
Cutting with dry-cutting blades:
Fill the water tank with clean water. Connect the GEKA-coupler of the water tank to the GEKA-coupler of the
fl oor saw. Check the ball valve is closed (ball valve lever in 90°-position to the water fl ow). For cutting open the
ball valve (ball valve lever in the water fl ow position) and the valve of the water tank (3).
Cutting operation
FS 130 B/FS 130 D/FS 170 S/FS 170 SD
1
2
1. Foot pedal - rising and
low er ing-
2. Depth control
Don't exceed the maximum recommended rpm speed for the blade!