9
Hydraulic and pneumatic equipment
Work on hydraulic equipment may be carried out only by persons having special knowledge and expe-
rience in hydraulic systems.
Check all lines, hoses and screwed connections regularly for leaks and obvious damage. Repair damage
immediately. Splashed oil may cause injury and fi re.
Depressurize all system sections and pressure pipes (hydraulic system, com pressed-air system) to be
removed in accordance with the specifi c instructions for the unit concerned before carrying out any repair
work.
Hydraulic and compressed-air lines must be laid and fi tted properly. Ensure that no con nec tions are in-
terchanged. The fi ttings, lengths and quality of the hoses must comply with the technical requirements.
Noise
During operation, all sound baffl es must be closed.
Always wear the prescribed ear protectors.
Oil, grease and other chemical substances
When handling oil, grease and other chemical substances, observe the product-related safe ty regulati-
ons.
Be careful when handling hot consumables (risk of burning or scalding).
For loading only use lifting gear and tackle of suffi cient capacity.
Appoint a competent marshaller to assist in the lifting operations.
Lift machinery and equipment properly with suitable lifting gear and only in ac cord ance with the operating
instructions (fi xing points for lifting tackle, etc . . .).
Only use suitable means of transport of adequate carrying capacity.
Fasten the loads safely using the suitable fi xing points.
Before or immediately after completion of the loading operations the machine must be secured by means
of recommended/supplied devices against un in ten tion al changes of po si tion and a corresponding war-
ning sign attached to the machine. Before recommissioning the machine these devices must be prop er ly
removed.
Carefully refi t and fasten all parts to be removed for transport purposes before recommissioning the
machine.
For recommissioning only proceed in accordance with the operating in struc tions.
2.7 Machinery and equipment used at frequently changing places of
operation)
3. Description
3.1 Intended use-description
Operate the fl oor saw only using tools in ac cord ance with the manufacturer’s instruction. Using other
tools is considered contrary to its des ig nat ed use. The manufacturer cannot be held liable for any damage
resulting from such use. The risk of such misuse lies entirely with the user.
Operate petrol driven fl oor saws only with motor fuel the engine manufacturer specifi es.
It is not allowed to move the machine with rotating blade outside of the area in which cutting works
have to be performed!
To Next Page
Loading...
Need help?
General
