GÖLZ FS 170 - Troubleshooting; Cutting Performance and Blade Issues

20
FS 130 /FS170
PROBLEM CAUSE REMEDY
Cutting
Dull diamond blade Sharpen or use softer
diamond blade
Floor saw rises
out of cut! Faulty gas pressure spring Replace
Feed too high Reduce feed
Damaged centering of Replace blade shaft
the blade shaft
Non circular abrasion
of the diamond blade! Warped blade shaft Replace
Loose or damaged Tighten or replace
blade shaft bearings
No free cut Replace diamond blade
because of sidewards
Diamond blade jams wear-out of segments
in the cut!
Damaged diamond Replace diamond blade
blade core
Insuffi cient water fl ow Check hoses for fracture
free laying
Wrong type of Choose different
Abnormal wear-out diamond blade diamond blade
of segments!
Feed too high Reduce feed
Cutting in loose under- Reduce cutting depth
ground
Insuffi cient water fl ow Check hoses for fracture
Abnormal blade wear- free laying
out at sides of core!
Cutting in loose under- Reduce cutting depth
ground
Slippy V-belts Adjust
Bad cutting performance!
Blunt diamond blade Sharpen or use softer
diamond blade