DIGITAL MANOMETER T210
11
QUICK ACCESS TO THE INGINEERING UNIT
The T210 manometer is equipped with a series of keys, U1, U2 etc. U6
provides the means of quick selection of the engineering unit for pressure
values.
These memories can be programmed using the following routine:
1.- Press and maintain the "UNIT" key until the desired engineering unit is
displayed on the screen.
2.- Then press the quick selection key to assign the new unit and maintain it
pressed until the desired engineering unit is displayed again.
3.- Verify the selection by pressing the recently programmed selection key
and check that the displayed unit is correct.
4.- Repeat previous points 1 to 3 for the remaining quick selection keys, if
required.
INSTRUMENT MENSSAGES
The T210 can display the following messages prior to or during operation:
LOW BATT: This indicates that the available battery power is below the
minimum recommended for the level of reliability and correct operation.
When this message appears, for continued instrument use, it must be
connected to the mains supply by means of the PS-30B battery charger,
which is supplied with the unit.
Power supply voltage: 220 Vac
Approximate recharge time: 16 hours
NOTE: In this way, the manometer can be continued to be used and the
batteries will be recharged.
To Next Page
Loading...
Need help?
General