20
05 Installation User Manual V1.4-2022-08-30
Mounting Support Requirements
• The mounting support shall be nonammable and reproof.
• Install the equipment on a surface that is solid enough to bear the inverter weight.
• Do not install the product on the support with poor sound insulation to avoid the noise
generated by the working product, which may annoy the residents nearby.
Installation Angle Requirements
• Install the inverter vertically or at a maximum back tilt of 15 degrees.
• Do not install the inverter upside down, forward tilt, back forward tilt, or horizontally.
0%~95%RH
IP65
ALT: 3000m
(*2000m for EH
series in Australia)
To Next Page
Loading...
Need help?
General
