Goodwe EH Plus Series - Communication Connection; Connecting the Communication Cable

36
06 Electrical Connection User Manual V1.4-2022-08-30
6.7 Communication Connection
6.7.1 Connecting the Communication Cable
NOTICE
• Make sure that the communication device is connected to the right COM port. Route the
communication cable far away from any interference source or power cable to prevent the
signal from being inuenced.
• DRED is only for Australia and New Zealand. Connect the DRED cable using a 6PIN
communication terminal. The communication cable and third-party DRED device should be
prepared by customers.
• Connect the remote shutdown cable using a 2PIN communication terminal. The
communication cable should be prepared by customers.
• Remove the resistor and keep it properly for later use.