To ensure heat dissipation and convenient disassembly, the minimum clearance around the
inverter should not be less than the following values.
The Upward part
The downward part
The front part
Both sides
Interval
------------ 200mm
-------- 500mm
---------------- 500mm
------------------- 1000mm
----------------------- 1200mm
500mm
1200mm1000mm 1000mm 500mm
200mm
Backboard Installation
Expansion Pipe
Nut
4.2.2 Mounting Procedure
1. Use the wall-mounted bracket as a template and drill 6 holes on the wall, 13 mm in diameter
and 65 mm deep.
2. Fix the wall-mounted bracket on the wall with six expansion bolts in accessory bag.
3. Carry the inverter with the handles on both sides of the inverter.
4. Place the inverter on the wall-mounted bracket as illustrated.
415
166.5
333
194
388
4.2 Equipment Installation
4.2.1 Select The Installation Location
1. Take the bearing capacity of the wall into account. The wall (such as concrete walls and metal
structures)should be strong enough to hold the weight of the inverter over a long period of
time.
2. Install the unit where it is accessible to service or do the electrical connection.
3. Do not install the unit on the wall of flammable material.
4. Make sure the installation location is well ventilated.
5. Inverters should not be installed near flammable or explosive items. Any strong electro-mag-
netic equipment should be kept away from installation site.
6. Install the unit at eye level to for convenient operation and maintenance.
7. Install the unit vertically or tilted backwards of no more than 15 degrees, no lateral tilt is
allowed. And wiring area should be facing downwards. Horizontal installation requires more
than 250mm off the ground.
4 Installation
4.1 Mounting Instructions
1. In order to achieve optimal performance, the ambient temperature should be lower than 45℃.
2. For easy maintenance, we suggest to install the inverter at eye level.
3. Inverters should not be installed near flammable and explosive items. Strong electro-magnetic
charges should be kept away from installation site.
4. Product label and warning symbols should be placed at a location that is easy to read by the
users.
5. Make sure to install the inverter at a place where it is protected from direct sunlight, rain and
snow.
Max
15°
Over
250mm
Accmulated snow
Keep away
from sunlight
Keep dry
Keep it clear
of snow
Sun Rain
09 10
To Next Page
Loading...
Need help?
General
