GoPro Hero session - CAPTURING PHOTOS; CAPTURING PHOTOS IN THE MODE THAT YOU USED LAST TIME

30 31
d. To change a setting, press the Menu button to move to the
setting, then press the Shutter button repeatedly to display
the option that you want.
e. Press the Menu button to move to the check mark, then press
the Shutter button to select it.
3. Press the Shutter button. Your camera beeps once, then beeps
once for each photo that is captured. The camera status lights blink
while the camera is capturing photos.
Note: To capture continous photos at a rate of 5 photos per second, select the Photo capture
mode, then hold down the Shutter button. Photos are captured until you release the button.
4. To power off the camera, press the Menu button to move to Exit
Photo Mode, then press the Shutter button to select it.
/ Capturing Photos
/ Capturing Photos
CAPTURING PHOTOS IN THE MODE THAT YOU USED LAST
TIME
To take a photo using the capture mode that you used most recently
(Photo, Burst, or Night), use the shortcut below.
1. Press the Menu button to turn on the status screen.
2. Press the Menu button to move to Enter Photo Mode, then press
the Shutter button to select it.
3. Press the Shutter button. The camera beeps once, then beeps
once for each photo that is captured. The camera status lights blink
while the camera is capturing photos.
4. To power off the camera, press the Menu button to move to Exit
Photo Mode, then press the Shutter button to select it.