Gorgy Timing LEDI 1.60 - WATERPROOF Case; PIVOTING Case to be Placed on a Table

23
MDE-LEDI160S-1012V1.0
3.2. WATERPROOF CASE:
All connections are made to the back of the case without opening it. Perform connections
according to the markings on the wires.
► Connect the 230VAC 50-60Hz supply.
► Connect the synchronisation input and the optional accessories (ASCII input, chro-
nometer, etc.)
☛ Attention: this clock must be a receiver, it cannot stand alone, and it
has no manual luminosity adjustment.
3.3. PIVOTING CASE TO BE PLACED ON A TABLE:
► All connections are made without opening the case. Perform connections according
to the markings on the wires.
► Connect the 230VAC 50-60Hz supply.
► Switch the battery main switch SW1 to the ON position (lower position).
☛ Attention: If clock display remains off, wait a few minutes for the
internal battery to charge.
ENGLISH