24
MDE-LEDI160S-1012V1.0
5. OPTIONS4. START-UP
► Setting the time is performed with three buttons, “+”, “– and “PROG”, that are
accessible on the back or on the side (pivoting case).
► With each press on the “PROG” button, a portion of the display begins to blink, and
the blinking portion is modied with the “+” and “– “ buttons (press the button conti-
nuously for faster forward or reverse).
► Setting cycle: 1 Setting the hour
2 Setting the minutes
► Luminosity is adjusted manually with the “+” and “-” buttons, outside of the time
setting cycle.
SYNCHRONISATION:
► If the minutes have not been modied: One press on “PROG” validates the new
programmed time without modifying the initial synchronisation (ex: modication of
the hour/temperature alternation or seasonal time change for stand alone clocks).
► If the minutes have been modied: One press on “PROG” makes the entire display
blink, which indicates that the clock is in synchronisation phase. A second press on
“PROG” makes it possible to synchronise the clock (press this second time at the
same moment as the minute cue provided by a time reference (e.g. the speaking
clock, Tel. No. 3699). The display then stops blinking.
To Next Page
Loading...
