Gorgy Timing LEDI 1.60 - 5 Options; Timer Option; Stopwatch Function; Count-Down

25
MDE-LEDI160S-1012V1.0
5. OPTIONS
5.1. TIMER OPTION
A switch is provided to move from the clock function to the chronometer (timer)function.
There are two possible uses in timer mode:
► Stopwatch
► Count-down
OPERATION :
A set time may be displayed if wished.
5.1.1. Stopwatch function
No set time :
► Press “START/+”. The timer will begin from zero and continue indenitely until the
“STOP” button is pressed.
With set time :
► Press the “PROG” button (this function can only be used when the timer is stop-
ped at zero) and set the required time using the “+” and “-“ buttons (each time the
“PROG” button is pressed, part of the display begins to ash; adjust the hours,
minutes and seconds in succession).
► When programming is completed, press on the “START/+” button. The timer will
begin at the time programmed and continue indenitely until the “STOP” button is
pressed.
5.1.2. Count-down
No set time :
► Press “START/-”. The timer will begin from zero and continue
for 24 hours or until the “STOP” button is pressed.
With set time :
► Press the “PROG” button (this function can only be used
when the timer is stopped at zero) and set the required time
using the “+” and “-“ buttons (each time the “PROG” button is
pressed, part of the display begins to ash; adjust the hours,
minutes and seconds in succession).
► When programming is completed, press on the “START/-”
button. The timer will begin at the time programmed and stop
automatically at zero, and then redisplay the set time.
ENGLISH