GMC-I Gossen-Metrawatt GmbH 29
GB
Note!
☞
If another measuring function is selected with the
rotary switch or the ESC|FUNC key, this has no influ-
ence on memory mode operation.
If the sampling rate is equal to or greater than 10 s,
the display is deactivated in order to extend battery
service life.
REM Display
The REM symbol indicates that the memory mode has
been activated. Individual storage events such as the stor-
age of measurement values are indicated by a brief disap-
pearance of the REM display. As long as the storage rate is
less than 1 s, REM blinks once per second.
SAMPLE Operating Mode
If the sampling rate has been set to “SAMPLE” (see chap-
ter 21.1.1), individual measurement values can be stored
manually from within the selected measuring function.
➭ Simultaneously press the ESC|FUNC and ON keys in order
to store each individual measurement value. REM blinks
briefly for each stored value.
DATA Operating Mode
Proceed as follows in order to store measurement values
with the “DATA” function:
➭ Set the sampling rate to “DATA”
(see chapter 21.1.1, page 40).
➭ Activate the memory mode.
➭ Press the DATA|CLEAR key in order to store measurement
values with the “DATA” function, i.e. after the measuring
signal has been applied and the display has settled to a
stable value (see chapter 5, page 12).
High Speed Storage Rate – Rapid Sampling
The following conditions prevail (for V DC) as long as the
storage rate is less than 0.05 s:
•
busy is still displayed at the LCD
• the decimal point is fixed:
automatic measuring range selection is disabled,
• all measurement values are stored to memory
• hysteresis is not active,
• the following are not utilized:
pre-trigger, st-in and st-ou (but rather trig off),
and cycle on
Memory Occupancy Query OCCUP
Memory occupancy can be queried from the INFO menu.
Occupancy is read out to the main display in % from
00.00% to 99.99%.
SEt inFo ↵ OCCUP ↵ XX.XX
To Next Page
Loading...
