44 GMC-I Gossen-Metrawatt GmbH
22.2 Selecting Interface Parameters
Addr – Address
If several multimeters, interfaces or memory adapters are
connected to the PC, each device requires its own
address. Address number 1 should be assigned to the first
device, 2 to the second device etc. If only one multimeter is
connected to the PC, address number 1 should be used.
SI232/rS232/bd232 – Interface Adapters
The type of interface adapter in use must be selected for
this parameter.
The SI232-II allows for on-site storage of measurement
values for METRA HIT 22/23/24/25/26 measuring instru-
ments. The “StorE” operating mode must be selected.
“online - transmission” must be selected for the uploading
of data to the PC (without memory).
ModEM
Indication must be made here as to whether or not a
modem has been connected between the adapter and the
PC.
*also for USB-HIT
no / yes
modem
onlin
store
bd232*
Interface Menu
↵
➧
➧
Flow Direction
=
=
Multimeter
Symbol Key
01 .... 99
set
addr
rs232
si232
modem
no / yes
To Next Page
Loading...
