Gossen MetraWatt METRA HIT 22S User Manual

GMC-I Gossen-Metrawatt GmbH 9
GB
Switching the Instrument On via PC (except for METRA HIT 22S)
After transmission of the first data block from the PC, the
multimeter is switched on. See also chapter 22, page 43.
Automatic Start-Up
The multimeter is switched on automatically in the transmit
or data storage mode.
Note!
☞
Electrical discharge and high frequency interference
can cause incorrect displays, and may block the
measuring sequence. To reset, switch the instru-
ment off, and then back on. If this procedure is
unsuccessful, briefly disconnect the battery from the
contact terminals.
Setting Time and Date
See chapter 21.1.3, page 40.
Switching the Instrument Off Manually
➭ Press and hold the ON key, until the display is deacti-
vated.
Deactivation of the instrument is acknowledged by two
brief acoustic signals.
Automatic Shut-Off
Your instrument shuts itself off automatically, if the mea-
surement value remains constant for a long period of time
(maximum measurement value fluctuation: approx. 0.8%
of the measuring range per minute or 1 °C or 1 °F per
minute), and if none of the keys or the rotary switch are
activated for a period of 10 minutes. Deactivation of the
instrument is acknowledged by a brief acoustic signal.
Exceptions are as follows:
Event counting, stopwatch, transmit or memory mode and
continuous operation.
Disabling Automatic Shut-Off
The instrument can also be switched to
“CONTINUOUS ON”.
➭ Simultaneously press the ON key and the multifunction
key ESC|FUNC when switching the instrument on. The
“CONTINUOUS ON” function is indicated at the LCD
with the symbol.

Gossen MetraWatt METRA HIT 22S Specifications

General

Brand	Gossen MetraWatt
Model	METRA HIT 22S
Category	Measuring Instruments
Language	English