9 - B.6.20.44-B
F22.060.03, issued on 01.98
The agitator is pneumatically driven: maximum permissible air inlet pressure: 6 bar.
Speed can be set on the built-in flow control valve. The ideal agitator speed for a particular
fluid must be determined by the user.
– The propeller of the agitator is enclosed within a protection ring.
– Techn. Product Description B.18.10.05-P
Reciprocating pumps with a fixed container are
particularly useful for smaller quantities of coating agent
(e.g. for repair paint jobs).
All wetted metal parts of the container are made from
austenitic stainless steel (-suitable for water-based paints).
Container capacity 5 l
Design certification for highly inflammable liquids class AI and AII is not required, since the
container is made entirely from stainless steel.
Suitable for use in areas with explosion hazards, because electrostatic charging cannot
occur.
– If the reciprocating pump with container is installed on a pump trolley, the connection unit is
fixed by a shim (can no longer be rotated).
In special cases, the reciprocating pumps are equipped
with suction system and cup (both described above). By
means of ball valves, it is possible to provide suction via
the suction system or from the cup.
Ball valve
Nominal diameter 25
Zinc-plated steel in the area in contact with the fluid
(- only suitable for water-based paints in certain
cases)
The rule for ball retaining valves: wings transverse to flow direction =line is closed
off
- Special constructions with two cups and ball valves in between or without ball
valves or with two suction systems and ball valves in between are also feasible.
When assembling or dismantling the suction system and the cup keep the ball valve in
position with an open-end spanner.
Connector 1
Cup
Connector 2
Cup
Suction
Ball valve
To Next Page
Loading...
