Setup
NOTE:
Refer to the turbine gun manual,
308-336,
for information on the operation and setup of the gun.
Connect the Fluid
and
Air Supply
1.
Connect the hose
to
the gun.
2.
Connect the gun air supply hose (A) between the
turbine air outlet (D) and the gun air inlet.
DO
tighten only. See Fig.
1.
NOT
use a wrench to tighten connections; hand-
3.
If
using a spray
gun
cup
(Bj,
connect the cup to
the gun fluid inlet.
4.
For CX-8 only;
If
using
an accessory remote pres-
sure pot
(C),
connect the fluid supply hose
(G)
between the gun fluid inlet and the remote pres-
sure pot.
Connect the air hose
(E)
between the pressure
pot air inlet and the compressor air outlet
(F).
NOTES:
The circled letters in Fig.
1
indicate hose line con-
*
Only the CX-8 turbine unit includes a compressor
Connect
to
Electric Supply
1.
Plug the sprayer power cord into a grounded out-
nections.
for use with a remote pressure pot.
let.
Air Control Valve
(used to shut
off
air
E
U
2-112
Gallon
Remote Pressure Pot
Part
NO.
M70604
(see
Accessories)
2
Quart
Remote Pressure
Pot
Part
No.
M70962
(see
Accessories)
CX-8
Turbine
shown
Fig.
1
02859
6
308-422
To Next Page
Loading...
Need help?
General
