Shutdown
WARNING
The
2
qt spray gun cups and accessow' remote
pressure pots remain pressurized until pressure is
manually relieved. To reduce the risk of serious
from the gun, always relieve
pressure in the cup or
injury from pressurized fluid or accidental spray
pressure pot before checking or servicing any pari
of
the spray system; before installing, cleaning or
changing fluid nozzles; before loosening or remov-
whenever you stop spraying.
ing the accessory remote pressure pot cover: and
1,
When spraying is finished, release the gun trigger
and turn
off
the air supply
to
the gun.
2.
Turn
off
the turbine sprayer.
The turbine hose outlet may be hot. Carefully
check the hose end before removing the hose,
WARNING
3.
If
using a remote pressure
pot,
relieve its pressure
by following these steps:
a. Turn
off
the air supply to the pressure pot.
b.
2
112
Gallon Remote
Pot:
Pull the pressure
relief valve ring
(205)
until pressure
is
com-
2
Quart fiemote
Pot:
Turn out the pressure
pletely relieved.
relief knob
(113)
about one turn. Wait until
pressure is completely relieved before remov-
ing the cover. Close the knob before using the
system again.
See Fig.
4.
E
u
02882
NOTE:
Elevate the spray gun and pull the trigger. This
will allow the fluid in the fluid hose to drain back into
the remote pressure pot.
4.
Clean the spray gun and cup as instructed in the
turbine gun manual,
308-336.
308-422
9
To Next Page
Loading...
Need help?
General
