Graco HFR - Appendix C - ADM Run Screens Overview

Appendix C - ADM Run Screens Overview
70 3A2797R
Appendix C - ADM Run Screens Overview
Run screens are divided into five major sections: status,
errors, events, and maintenance. The following diagram
demonstrates the flow of the Run screens beginning
with the Home screen.
Home Screen
The Home screen is the first screen that displays in the
Run screens. It shows the current fluid pressure on the
A (Red) and B (Blue) fluid outlets of the pump and if
there are any active errors. If tanks are installed in the
system, the fill level is shown on each tank. The ratio is
also displayed as either Red:1 or Blue:1 depending on
which display has been setup. See System Screen 3
on page 61.
To select an operating mode, press repeatedly until
the desired mode is shown then press to select the
mode. Alternately, press and use the up and down
arrow keys until the desired mode is shown, then press
to select the mode. The available operating modes
are operator, sequence, shot, standby, night, and dis-
abled.
Home Screen, Disabled Mode
When this mode is selected, the machine will not be
able to dispense or condition (heat/cool) material. The
setup screens cannot be accessed while in Disabled
mode. Use the Select mode button to exit Disabled
mode.
FIG. 29: Run Screens Navigation Diagram
Maintenance
Home Status Events #1
Events #2
Events #...
Errors #1
Errors #2
Errors #...