Installation
312877A 11
Key for FIG. 3 and FIG. 4:
A Air supply line
B Bleed-type master air valve (required for pump)
C Air regulator
D Air inlet
E Master air valve (for accessories)
F Air line filter
G Fluid suction line
H Bung adapter
J Fluid drain valve (required)
K Fluid shutoff valve
L Fluid line
M Fluid inlet (Aluminum, F
IG. 3, four ports, one
not visible; Plastic, F
IG. 4, center or end flanges
available; Stainless Steel, not pictured, one
port)
N Fluid outlet (Aluminum, F
IG. 3, four ports, one
not visible; Plastic, F
IG. 4, center or end flanges
available; Stainless Steel, not pictured, one
port)
R Ground wire (required for aluminum,
conductive polypropylene, and stainless steel
pumps; see page 7 for installation instructions)
FIG. 4. Typical floor-mount installation (polypropylene, 1050P, pump shown)
E
F
CB
A
KL
J
R
D
G
M
N
ti14164a
To Next Page
Loading...
