308981 23
Overmolded Diaphragms: Repeat Step 5 for the other
end of the diaphragm shaft (15).
8. Install the muffler (3).
NOTE: When you install the vee clamps in step 9, orient
the center housing (11) so the air inlet is approximately
45° above horizontal and the muffler (3) is
approximately horizontal.
9. Apply thin, even film of grease to inside of vee
clamp (109).
10. Position the fluid covers (101), install the vee
clamps (109) around the fluid and air covers,
install the grounding strip on the vee clamps, and
torque the vee clamp nuts to 80 to 90 in-lb (9 to
10 N-m). See Torque Sequence, page 32.
11. Make sure all the check valve parts are in place.
See
Fig. 9.
12. Install the manifolds (102), and torque the mani-
fold bolts (105) to 80 to 90 in-lb (9 to 10 N-m).
See Torque Sequence, page 32.
To Next Page
Loading...
