Graco HVLP Series Instructions-Parts List

24 pages

To Next Page

309205

Rev. D

Cup Feed

Includes 1-quart (1 liter) cup

Model 244113, without fluid set

Model 244117, with # 3 fluid set

T10746

Remote Pressure Feed

Model 244115, without fluid set

Model 244118, with # 3 fluid set

INSTRUCTIONS–PARTS LIST

INSTRUCTIONS

This manual contains important

warnings and information.

READ AND KEEP FOR REFERENCE.

US Patent Pending

HVLP–Turbine Guns

10 psi (0.07 MPa, .7 bar) Maximum Inlet Air Pressure

50 psi (0.35 MPa, 3.5 bar) Maximum Inlet Fluid Pressure

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441

Graco Inc. is registered to I.S. EN ISO 9001

Parts

Other manuals for Graco HVLP Series

B
bishopdennisAug 21, 2025
Why is my Graco Paint Sprayer not starting?
- J
  jenniferspencerAug 21, 2025
  If your Graco Paint Sprayer isn't starting, there are several potential causes related to power. First, ensure the electrical outlet has power and cycle the ON/OFF switch. Check that the correct power cord is properly plugged in. Also, examine the circuit breaker and push to reset it if necessary. If the issue persists and you have a ProContractor or ProComp model in AutoStart, confirm the air valve before the gun is open and trigger the gun.
S
Susan BennettAug 23, 2025
Why is fluid leaking between the cup and ring on my Graco Paint Sprayer?

General

Brand	Graco
Series	HVLP Series
Type	HVLP Paint Sprayer
Spray Technology	HVLP (High Volume Low Pressure)
Air Inlet Size	1/4 inch
Hose Length	N/A (Requires separate air hose)