What to do if my Graco Pro Xp H60T10 Paint Sprayer's ES or Hz indicator is amber?
If the ES or Hz indicator on your Graco Paint Sprayer is amber, the alternator speed is too low. Increase the air pressure until the indicator is green. To avoid over-atomization, use the atomizing air restrictor valve to reduce the atomizing air to the air cap.
What to do if my Graco Pro Xp H60T10 is not spraying?
If your Graco Paint Sprayer is not spraying, first check if the fluid supply is low and add fluid if necessary. A damaged spray tip can also cause this, so replace it. The spray tip might also be dirty or clogged, so clean it.
What to do if my Graco Pro Xp H60T10 Paint Sprayer is producing excessive spray fog?
Excessive spray fog from your Graco Paint Sprayer could be due to atomizing air pressure being too high. Try closing the atomizing air valve part way, or decreasing the air pressure as low as possible, keeping in mind that a minimum of 45 psi (0.32 MPa, 3.2 bar) is needed at the gun for full voltage. Also, the fluid may be too thin. In this case, increase the viscosity or increase the fluid flow rate.
Why does my Graco Pro Xp H60T10 Paint Sprayer have tails in the pattern?
If your Graco Paint Sprayer's pattern has tails, it could be due to air pressure that is too low. Open the atomizing air adjustment valve. Alternatively, the fluid pressure may be too low, so increase it.
Why does my Graco Pro Xp H60T10 Paint Sprayer have a pattern pushed to one side and a dirty air cap?
If the spray pattern of your Graco Paint Sprayer is pushed to one side and the air cap gets dirty, it's likely that the air cap holes are plugged. Clean the air cap.
Why does my Graco Pro Xp H60T10 have excessive paint wrap back to the operator?
Excessive paint wrap back to the operator with your Graco Paint Sprayer is often due to poor grounding. Also, check that the distance from the gun to the part is correct; it should be 8–12 in. (200–300 mm).
Why am I getting a shock from the workpiece when using my Graco Paint Sprayer?
If you're getting a shock from the workpiece when using your Graco Paint Sprayer, the workpiece is not grounded properly. Resistance must be 1 megohm or less, so clean the workpiece hangers.
What to do if my Graco Pro Xp H60T10 shows an error display and the Hz indicator is red (Smart guns only)?
If your Graco Paint Sprayer displays an error and the Hz indicator is red (Smart guns only), the smart module has lost communication with the power supply. Check for good connections between the Smart Module and power supply.
What to do if my Graco Pro Xp H60T10 Paint Sprayer's ES or Hz indicator is not lit?
If the ES or Hz indicator on your Graco Paint Sprayer is not lit, ensure the ES On/Off switch is in the ON (I) position. Also check the power supply, alternator, and alternator ribbon cable.
What causes 'orange peel' finish with my Graco Paint Sprayer?
An "orange peel" finish with your Graco Paint Sprayer can occur if the atomizing air pressure is too low. Open the atomizing air valve more or increase gun air inlet pressure, using the lowest air pressure necessary. It could also be that the spray tip is too large, so use a smaller tip. Poorly mixed or filtered fluid can also cause this, so remix or refilter the fluid. Finally, the fluid might be too thick, so reduce the viscosity.
General| Brand | Graco |
|---|---|
| Model | Pro Xp H60T10 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
