Setup
3A9031A 13
Spray Tip Installation
1. Perform Pressure Relief Procedure,
page 10.
2. Engage trigger lock.
3. Verify spray tip and tip guard parts are
assembled in the order shown.
a. Use spray tip to align gasket and
seal in the tip guard.
b. Spray tip must be pushed all the
way into the tip guard. Turn spray
tip to push down.
c. Turn the arrow shaped handle on
the spray tip forward to the spray
position.
4. Screw spray tip assembly onto the gun
and tighten.
5. Return spray to holder.
6. Place trigger guard in front of nut on gun
holder. Tighten knob.
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip when installing or removing the Spray
Tip and Spray Tip Guard.
To Next Page
Loading...
