Startup
18 3A9031A
Fill Gun and Hose
1. Hold gun against a grounded waste pail.
Point gun into waste pail.
a. Loosen gun retainer knob and
remove spray gun from holder.
b. Disengage trigger lock.
c. Pull and hold gun trigger.
d. Turn Prime/Spray valve to SPRAY
position.
e. Press ON/OFF switch to ON
position. Button is illuminated
when ON.
2. Trigger gun into waste pail until only
paint comes out of the gun.
3. Release trigger. Engage trigger lock.
4. Transfer drain tube to paint pail and clip
to siphon tube.
5. Return gun to gun holder.
NOTE: When motor stops sprayer is ready to
paint. If motor continues to run sprayer is not
properly primed, repeat Fill Pump and Fill
Gun and Hose.
To Next Page
Loading...
