Typical Installation
12 3A7004B
All electrically conductive objects or devices in the
spray area, including paint containers, wash cans and
tools, must be properly grounded.
All persons entering
the spray area: shoes
must have conductive
soles, such as leather, or
personal grounding
straps must be worn.
Rubber or plastic shoe
soles are not conductive.
The operator must not
wear gloves that insu-
late the hand from the
spray gun. The gloves
must be conductive or
modified as shown.
The floor of the spray area must be electrically con-
ductive and grounded. Do not cover the floor with card-
board or any non-conductive material that would
interrupt grounding continuity.
Flammable liquids in the spray area must be kept in
approved, grounded containers. Do not store more than
the quantity needed for one shift.
Fluid supply container: follow local code.
All solvent pails: follow local code. Use only conductive
metal pails, placed on a grounded surface. Do not place
the pail on a non-conductive surface, such as paper or
cardboard, which interrupts grounding continuity.
DataTrak: The DataTrak electronic monitoring system is
required to be grounded. Do not remove it from its stan-
dard mounting location on the air control panel.
Setup
1. See FIG. 1. Attach the gun fluid hose (Z) to the fluid
regulator (G) outlet.
2. Attach other end of the gun fluid hose (Z) to the gun
fluid inlet.
3. Attach the right-hand thread end of the air hose
(AA) to the gun air regulator (T).
4. Attach the left-hand thread end of the gun air hose
(AA) to the Electrostatic air spray gun (H) air inlet.
5. Apply lens cover to both regulator gauge lenses.
6. Verify that suction hose fittings are tight.
Cut off
finger of
glove
Cut out 3 in.
(76 mm) square
from palm of
glove.
To Next Page
Loading...
