3A9522A
EN
Instructions
Pulse
®
Tank Level
Monitor (TLM)
Measures the distance between the device and the surface of the fluid beneath it to
determine the volume of fluid within a tank. Use with a Pulse operating system only.
Intended fluids: oil, waste oil, automatic transmission fluid (ATF), anti-freeze, windshield
washer solution, and waste water. For professional use only. Not suitable for tank overfill
protection.
Not approved for use in European explosive atmosphere locations.
Part No. 2007428
Contains IC: 1846A-XBEE3
Contains FCC ID MCQ-XBEE3. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
Important Safety Instructions
Read all warnings and instructions in this manual
before using the equipment. Save these
instructions.
NOTICE
•
Do not over tighten TLM into tank
bung! Over tightening can cause per-
manent damage and result in inaccu-
rate readings.
• Do not use thread sealant or adhe-
sive! Many of these products are
chemically incompatible with the ABS
plastic. PTFE tape is acceptable.
To Next Page
Need help?
General
