Set Up
3A9522A 5
Set Up
1. Install four, AA alkaline batteries (9) in
the battery holder (8). See Replace the
Batteries, page 14, Steps 1 - 6.
Register the TLM
Register the TLM prior to installation.
The TLM operating parameters are
controlled by the Pulse software and are set
up by the System Administrator.
NOTE: Any manual TLM readings taken
before the TLM is configured will be
incorrect.
To register the TLM:
1. On the Pulse web portal set the Hub, or
the remote extender that the TLM
communicates with, to DISCOVERY
mode.
2. Press and hold the Display button (A)
until the display (B) reads REGISTER,
then release (F
IG. 2). This may take up to
20 seconds.
NOTE: A TLM displays REGISTER only if a
Hub, or remote extender, is within range and
in DISCOVERY mode.
3. REGISTER OK (F
IG. 3, page 6) displays
when the TLM is registered with the
Pulse software. This may take up to 20
seconds.
Do not install or service this equipment
unless you are trained and qualified.
Installing and servicing this equipment
requires access to parts which may cause
fire, explosion, and serious injury if work is
not performed properly. Read Warnings,
page 3.
NOTICE
Do not over tighten TLM into tank bung!
Over tightening can cause permanent
damage and result in inaccurate readings.
Do not use the TLM with pressurized
tanks. Using the TLM in a pressurized tank
will damage the TLM.
Do not use thread sealant or adhesive.
Many of these products are chemically
incompatible with the Pulse/ABS plastic.
PTFE tape is acceptable.
FIG. 1
FIG. 2
To Next Page
Loading...
