Graco ThermoLazer ProMelt - Removal of FlexDie Screed Box; Burn Hazard During Removal

Screed Box ThermoLazer 200/200TC (FlexDie)
24 3A1319K
Removal
1. Shut off screed box burners.
2. Remove the two gas hoses from quick release cou-
plings (10).
3. Push in and turn spring loaded handle 90 degrees
and remove from yoke (31).
4. Remove bolt and slide FlexDie box off.
ti122669a
Front
Rear
ti22675a
10
10
ti22676a
31
BURN HAZARD
Make sure to use two hands when picking up screed
box. Place one hand on yoke and one hand on rod.
Do NOT pick up screed box with one hand and/or at
one location.
ti22677b
a
ti17047b
ti17048b