Maintenance
3A1319K 37
FatTrack Front Swivel Wheel
System
(ThermoLazer 300TC/ProMelt)
ANNUALLY: Tighten nut on screw under dust cap until
spring washer bottoms out. Then back off the nut 1/2 to
3/4 turns.
ANNUALLY: Tighten nut on screw until it begins to
compress spring washer. Then tighten an additional 1/4
turn.
MONTHLY: Grease the wheel bearing.
PERIODICALLY: Check caster locking pin for wear. If
pin is worn out, there will be play in the caster wheel.
Reverse or replace the pin as needed.
PERIODICALLY: Check caster wheel alignment as
necessary.
FatTrack Front Swivel Tire Alignment
Align front wheel as follows:
1. Loosen cap screw (86h).
2. Rotate front wheel fork left or right, as necessary, to
straighten alignment.
3. Tighten cap screw (86h). Push striper and let striper
roll with hands off of striper.
NOTE: If striper rolls right or left, then repeat steps 1
and 3 until striper rolls straight.
To Next Page
Loading...
