Screed Box Line Thickness Adjustment
28 3A1319K
Screed Box Line Thickness Adjustment
(All ThermoLazer units)
NOTE: 1/4 turn will change line thickness by .013 in.
(0.3 mm). Turn the line adjustment screw clockwise for a
thinner line, or counterclockwise for a thickaer line.
Typical settings on pavement: 0.060 - 0.125 in.
(0.153 - 0.318 cm).
Typical settings on metal stencil: Flush - 0.0 in. (0.0 cm).
1. Move screed box actuator to middle position. Make
sure screed box is closed and resting on the
ground. NOTE: All screed boxes are initially set at
90 mil (1.8 mm). Adjustment may be required before
first use.
2. Use a flat screwdriver to turn line adjustment screws
clockwise so that line thickness is zero.
3. Turn line adjustment screws counter-clockwise until
desired line thickness is reached.
Measure line thickness after applying thermoplastic and
adjust as necessary.
X
X
mil # Turns
30 0.6
60 1.2
90 1.8
120 2.4
150 3.0
mm # Turns
0.5 0.4
1.0 0.8
1.5 1.2
2.0 1.6
To Next Page
Loading...
