Hi/lo Weight control –
PluPro
Weight limit function helps to indicate if a weight is within a particular range, transmitting a visual signal through the
colours on the display and the bottom bars of the display with the option of also sending out a sound signal through
the indicator.
The indicator shows a bar with a negative left side and a positive right side. The indication of limits through the
lighting of the display can be set up in this menu, as well as the type of sound signal that will be sent out.
This function can be used with our optional relay card for the connection of external warning or control elements.
The indicator has 20 memory slots for this function.
Memorising weight limits and response mode
1.
Press and search for the
“
PLuPro
”
option in the menu. Press the button to confirm. The
display will show ‘
PLU
,,
’, where ‘XX’ is the memory slot for the limits function.
2.
To access the required memory slot, use the
and cursors to increase or decrease
the position until you find the desired one.
3.
Confirm by pressing .
4.
It will show ‘
tAr
’ for a moment and then it will immediately show ‘
000000
’ where the nominal value must be
To Next Page
Loading...
