Gram K3X Series User Manual

11
5. SOFTWARE VERSION IDENTIFICATION
Firmware version is V 6.xxx, where “xxx” is referred to different functions
which doesn’t affect legally relevant parameters.
K3X terminal display shows for 2” the embedded software version after
power on.
Full information on K3X terminal module and Xtrem ADPD module can be
show on the LCD display by following next steps:
Press to enter the menu settings.
Press  button until the display shows the option , then press 
The following information will be shown:
K3X terminal embedded software version (V 6.xxx)
K3X terminal production reference (lot)
Related information on the Xtrem scale connected:
Serial number XXXXXX
Seal switch state as “UNPROT” / “PROT”
Software version as “S 3.007”
Weighing scale full capacity and verification interval.
Full information on the weighing scale configuration can be print using the
menu settings option:
→ ... →  → … →  →…→ 

Gram K3X Series Specifications

General

Brand	Gram
Model	K3X Series
Category	Scales
Language	English