Select the menu “Other Services” – “Zero Configuration” – “Zero Configuration Settings”, Select “Enable Zero Config”
(enabled by default) and “Enable Pick Extension”, and click “Pick Extension Segment” to set the optional number segment.
Zero Configuration settings
Click “Pick Extension Segment” to switch to the menu “PBX Settings” – “General Settings”, and enter the corresponding
number segment value. Make sure to click save afterward to save the changes.
Picking Extension Segments
The UCM6301 automatically discovers and manages device addresses on the same network segment. At the same time,
UCM supports manual input of device IP to discover devices.
Note
If the corresponding model cannot be downloaded and installed to the UCM local PC due to network reasons, you can upload
the file of the UCM zero-configuration template (.pack file) and click the Download and Install button.