GRP260x Administration Guide
Version 1.0.1.18
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".
• Default Mode:
➢ When the phone is in idle, press HEADSET button to off hook the
phone and make calls by using headset. Headset icon will display on
the screen in dialing/talking status.
➢ When there is an incoming call, press HEADSET button to pick up the
call using headset.
➢ When there is an active call using headset, press HEADSET button to
hang up the call.
➢ When Speaker/Handset is being used in dialing/talking status, press
HEADSET button to switch to headset. Press it again to hang up the
call. Or press speaker/Handset to switch back to the previous mode.
• Toggle Headset/Speaker:
➢ When the phone is in idle, press HEADSET button to switch to Headset
mode. The headset icon will display on the left side of the screen.
➢ In this mode, if pressing Speaker button or Line key to off hook the
phone, headset will be used.
When there is an active call, press HEADSET button to toggle between
Headset and Speaker.
Selects whether the connected headset is normal RJ11 headset, Plantronics
EHS, Jabra EHS, Sennheiser EHS headset.
Configures to enable or disable the speaker to ring when headset is used on
"Toggle Headset/Speaker" mode. If set to "Yes", when the phone is in Headset
"Toggle Headset/Speaker" mode, both headset and speaker will ring on
incoming call. The default setting is "No".
Configures the transmission gain of the headset. The default value is -6dB.
Configures the receiving gain of the headset. The default value is -6dB.
To Next Page
Loading...
Need help?
General
