Mute on Answer
Intercom Call
When enabled, phone will mute the incoming intercom call based on Call-Info/Alert Info Headers.
Default is disabled.
Transfer on 3-way
Conference Hang up
Transfers conference from hosted party when hang up, thus other parties can continue the
conference without interruption. Default is unchecked.
Use # as Dial Key
Treats “#” as the “Send” (or “Dial”) key when set to “Yes”. If set to “No”, this “#” key can be included
as part of the dialed number or it will be used as redial key when the input area has no number
(please make sure the dial plan is properly configured to allow dialing # out). Default is “Yes”.
Use # as Redial Key
Allows users to configure the "#" key as the "Redial" key. If set to "Yes", the "#" key will immediately
redial the last call. In this case, this key is essentially equivalent to the "Redial" key. If set to "No", the
"#" key is treated as part of the dialed string. Default is “Yes”.
DND Call Feature On
Configures the feature code to enable the DND (Do Not Disturb) feature for this account. If it is
configured, the phone will dial the feature code automatically when the DND feature is enabled.
DND Call Feature Off
Configures the feature code to disable the DND (Do Not Disturb) feature for this account. If it is
configured, the phone will dial the feature code automatically when the DND feature is disabled.
No Key Entry Timeout
(s)
Determines the expiration timer (in seconds) for no key entry. The dialed digit will be sent out if no
other digits entered within the set period. The default value is 4 seconds. The valid range is 1 - 15.
This feature does not work if the dialer page is entered via the Account Widget on the phone.
Ring Timeout (s)
Defines the expiration timer (in seconds) for the rings with no answer.
The default setting is 60. The valid range is from 10 to 300.
Refer-To Use Target
Contact
Sets the phone system to use the target’s Contact header tag to the Refer-To header in the SIP
REFER message during an attended transfer.
The default setting is “No”.
RFC2543 Hold If yes, c=0.0.0.0 will be used in INVITE SDP for hold.
Call Forwarding
Call Forward Type
Sets the Call Forwarding feature for this account.
●
None: Disable call forwarding feature.
●
Unconditional: Set to forward all calls to a specified account.
●
Time based: Set the call forwarding rule based on time. The system can forward incoming calls
to the accounts of In Time Forward to and Out Time Forward to.
●
Others: Set the call forwarding rule based on following account status.
1.
Forward when Busy: the call will be forward to number set under “Busy To” when the account
is busy.
2.
Forward when No Answer: The call will be forwarded to the number set under “No Answer To”
after the configured timeout. (range 1- 120s)
3.
Forward when DND: When the phone is on DND mode the call will be forwarded to number
configured under “DND To”.
Dial Plan
Dial Plan Prefix Configures the digits prepended to the dialed number.
To Next Page
Loading...
Need help?
General
