Record Mode
Configures recording mode.
●
If set to (Default) “Record locally”, the phone will use the local recorder for call recording, and the
audio file will be saved according to the recorder setup.
●
If set to “Record on PortaOne”, the phone will send the specified SIP messages to the
corresponding server;
●
If set to “Record on UCM”, the phone will send the recording feature code to the UCM server to
request for recording, and the recording function will be executed by the server.
●
If set to “SD card”, the phone will use the SD card for call recording.
●
Set “Disabled” to ignore this feature
Enable Auto Record
When Call
Established
Configures whether to auto record when a call is established. If set to “Yes”, the call recording will start
automatically when the call is established.
Rejected Call
Notification
Enable/Disable rejected call notification. Once enabled, a missed call will prompt on LCD when reject
the incoming call.
Default is “No”.
Return Code When
Rejecting Incoming
Calls
When rejecting an incoming call, the phone will send the selected type of SIP response for the call.
Return Code When
DND Is Enabled
When DND is enabled, the phone will send the selected type of SIP response
Group Listen with
Speaker
Configures whether to enable speaker audio output when in a call with handset/headset. If enabled,
the speaker audio output is enabled, but you cannot talk through the speaker.
One-Way Call
Function Buttons
Users can configure and customize the call functions in the call interface during a normal call. The
available call functions are: Mute, Hold, Video, Record, Transfer, Call Details, New Call, Keyboard,
Media Channel, Conference.
Note: Users can choose only 3 of these functions to be shown on the call interface during a one-way call.
Conference Call
Function Buttons
Users can configure and customize the call functions in the call interface during a conference. The
available call functions are: Invite, Mute, Hold, Record, Call Details, New Call, Keyboard, Media
Channel.
Note: Users can choose only 3 of these functions to be shown on the call interface during a conference.
Call Function Button
Display Timeout (s)
Configures the timeout period for call function buttons display. If set to “0”, the buttons will be always
displayed. The value range is 0-30 seconds.
Table 27: Phone Settings/Call Settings
Phone Settings/Ringtone
Auto Config CPT by
Region
Configures whether to choose Call Progress Tone automatically by region. If set to “Yes”, the
phone will configure CPT (Call Progress Tone) according to different regions automatically. If set
to “No”, you can manual configure CPT parameters.
The default setting is “No”.
To Next Page
Loading...
Need help?
General
