P a g e | 60
GXW42xx User Manual
Version 1.0.15.30
Incoming call will stop ringing when not picked up given a specific period of time.
Delayed Call
Forward Wait
Timeout
Default value is 20 seconds. In case this feature activated using * codes (*92 code),
the call will be forwarded after this preconfigured amount of time.
If this parameter is set to “Yes”, the “From” header along with Privacy and
P_Asserted_Identity headers in outgoing INVITE message will be set to anonymous,
blocking Caller ID.
Default is No. If set to Yes, incoming calls with anonymous Caller ID will be rejected
with 486 Busy message.
Linear and Circular. Linear style will sort the call to the lowest-numbered available line,
this is also called “serial hunting”. Circular style will distribute the calls "round-robin".
If a call is assigned to line 1, the next call goes to 2 and the next to 3. The succession
throughout each of the lines continues even if one of the previous lines becomes
available. When the end of the hunt group is reached, the hunting starts over at the
first line. Lines are skipped if they are still busy on a previous call. These two hunting
styles can be configured from the Profile X page.
Hunting Group
Ring Timeout
Default is 20 seconds. If call is not answered within this designated time period, the
call will be forwarded to the next member of a Hunt Group.
Default is Standard. Choose the selection to meet some special requirements from
Softswitch vendors. Example of vendors - CBCOM, RNK.
Default is Yes. Yes will allow you to customize the star code for each call feature. No
will disable all, and Enable All will active all.
Default is Yes, and star code is Enable-16, Disable-17.
Default is Yes, and star code is Enable-18, Disable-19.
Default is Yes, and star code is Enable-31, Disable-30.
Default is Yes, and star code is Enable-82, Disable-67.
To Next Page
Loading...
Need help?
General
