Grandstream Networks GXW42XX series User Manual

FIRMWARE 1.0.4.4 GXW42XX USER MANUAL PAGE 35 OF 57
Keep-Alive Interval
Specifies in seconds how often the phone sends a blank UDP packet
to the SIP server in order to keep the "ping hole" on the NAT router to
open. The default is 20 seconds.
Upgrade and Provisioning
Lock Keypad
Update
If set to “Yes”, the configuration update via keypad is disabled.
Firmware Upgrade
and Provisioning
Specifies how firmware upgrading and provisioning request to be sent.
There are three options to choose from: “Always Check for New Firmware”, “Check New
Firmware only when F/W pre/suffix changes”, and “Always Skip the Firmware Check”.
XML Config File
Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User
Name
The user name needed to authenticate withthe HTTP/HTTPS server.
HTTP/HTTPS
Password
The password needed to authenticate with the HTTP/HTTPS server.
Upgrade via
Allows users to choose the firmware upgrade method via TFTP, HTTP or HTTPS.
Firmware
Server Path
IP address or domain name of firmware server. That URL of the server that hosts the firmware
release. The default server is: fm.grandstream.com/gs
Config Server
Path
IP address or domain name of configuration server. The server hosts a copy of the configuration
file to be installed on the gateway. The default server is: fm.grandstream.com/gs
Firmware File
Prefix
Default is blank. If configured, GXW42XX will request firmware file with the prefix. This setting is
useful for Internet Telephone Service Providers. End users should keep it blank.
Firmware File
Postfix
Default is blank. This setting is useful for Internet Telephone Service Providers. End users should
keep it blank.
Config File
Prefix
Default is blank. This setting is useful for Internet Telephone Service Providers. End users should
keep it blank.
Config File
Postfix
Default is blank. This setting is useful for Internet Telephone Service Providers. End users should
keep it blank.
Allow DHCP
Option 43 and
Option 66 to
Override Server
If set to “Yes”, configuration and upgrade server’s information can be obtained using DHCP
option 66 from DHCP server. This option specifies the URL of the tftp server.
Note: If DHCP Option 66 is enabled, the gateway will attempt downloading a configuration file
from the server URL provided by DHCP, even though Config Server Path is left blank.

Grandstream Networks GXW42XX series Specifications

General

Brand	Grandstream Networks
Model	GXW42XX series
Category	Gateway
Language	English