Grandstream Networks UCM6304A User Manual

P a g e | 146
UCM630xA Series User Manual
Version 1.0.9.10
Create New Device
Besides configuring the device after the device is discovered, users could also directly create a new device and
configure basic settings before the device is discovered by the UCM630xA. Once the device is plugged in, it can
then be discovered and provisioned. This gives the system administrator adequate time to set up each device
beforehand.
Click on "Add" and the following dialog will show. Follow the steps below to create the configurations for the new
device.
1. Firstly, select a model for the device to be created and enter its MAC address, IP address and firmware
version (optional) in the corresponding field.
2. Basic settings will show a list of settings based on the model selected in step 1. Users could assign
extensions to accounts, assign functions to Line Keys and Multiple-Purposed Keys if supported on the
selected model.
3. Click on “save” to save the configuration for this device.
Figure 71: Create New Device
Manage Devices
The device manually created or discovered from Auto Discover will be listed in the Web GUIValue-added
FeaturesZero ConfigZero Config page. Users can see the devices with their MAC address, IP address,
vendor, model etc.

Grandstream Networks UCM6304A Specifications

General

Brand	Grandstream Networks
Model	UCM6304A
Category	PBX
Language	English