Grandstream Networks UCM6510 - Configuring Digital Trunk; Figure 13: Create New Digital Trunk; Figure 14: Configure Digital Trunk

How to Configure T1 Trunk on UCM6510 Page 11 of 17
4. CONFIGURING DIGITAL TRUNK
4.1. Go to UCM6510 web UI->PBX->Basic/Call Routes->Digital Trunks page. Click on “Create New
Digital Trunk”.
Figure 13: Create New Digital Trunk
4.2. Configure trunk name to identify this digital trunk. Select “Channel Group” to the default group for this
trunk. Configure CallerID, Auto Record and Fax Detection options as needed.
Figure 14: Configure Digital Trunk
4.3. Click on “Save” on the bottom of the dialog.
4.4. Click on “Apply Changes” on the upper right of the web page.
4.5. Go to web UI->Status->PBX Status page to check trunk status.