How to Configure T1 Trunk on UCM6510 Page 8 of 17
3. CONFIGURING DIGITAL PORT
3.1. Before configuring digital trunk, please check the physical connection of the T1/E1/J1 port as
described in section [1. CONNECTING] to make sure the correct type of cable is used and properly
connected.
3.2. Go to UCM6510 web UI->PBX->Ports Config->Digital Hardware page. Click on to configure the
digital port.
Figure 10: Configure Digital Port 1
3.3. There are two tabs in the dialog to configure the digital port.
Basic Settings: this includes span type and signaling configurations.
To Next Page
Loading...
