How to Configure T1 Trunk on UCM6510 Page 12 of 17
Figure 15: Digital Trunk Status
If the status shows “Available”, the digital trunk is successfully configured and should work as expected
now. If it shows “Unavailable” or “Error configured”, please check digital port configuration as
described in section [3. CONFIGURING DIGITAL PORT], reconfigure, save and apply the changes again.
4.6. Configure inbound routes for this digital trunk under web UI->PBX Status->Basic/Call Routes->
Inbound Routes.
4.7. Configure outbound routes for this digital trunk under web UI->PBX Status->Basic/Call Routes->
Outbound Routes.
Until now the digital trunk has been completely configured and users should be able to make inbound and
outbound calls.
To Next Page
Loading...
