How to Configure T1 Trunk on UCM6510 Page 3 of 17
OVERVIEW
The UCM6510 supports T1/E1/J1 digital trunk and data trunk. Digital trunk allows voice transmission in
digital signal while data trunk is used for data transmission so that the device can connect to the Internet.
On the UCM6510, the system administrator can configure both trunks allowing voice and data
transmission at the same time by specifying the channels. This document introduces how to set up T1
trunk on the UCM6510 as a configuration sample.
Figure 1: Sample T1 Topology Using UCM6510
For more information about how to configure UCM6510, please refer to the UCM6510 user manual in
www.grandstream.com/support.
To Next Page
Loading...
