Grandstream Networks UCM6510 - Configuring Data Trunk; Figure 16: PBX->Basic;Call Routes->Data Trunk; Figure 17: Configure Data Trunk

How to Configure T1 Trunk on UCM6510 Page 13 of 17
5. CONFIGURING DATA TRUNK
5.1. Go to UCM6510 web UI->PBX->Basic/Call Routes->Data Trunk page. Click on to edit the data
trunk.
Figure 16: PBX->Basic/Call Routes->Data Trunk
5.2. Configure the data trunk in the Data Trunk dialog.
Select the group 2 we created in section [2. CONFIGURING T1 CHANNELS] as the channel group.
Users will not be able to select the group that has been already used.
Figure 17: Configure Data Trunk
5.3. Click on “Save” on the bottom of the dialog.
5.4. Reboot the UCM6510 for the data trunk configuration to take effect.
5.5. Once the UCM6510 boots up, go to UCM6510 web UI->PBX->Basic/Call Routes->Data Trunk page