In this mode no info is displayed in the machine display.
For updateing and uploading
:
Press “Run from Flash”.
Update date and time to the PC-settings, by pressing “Set Time”.
Upload software and language file by pressing “Program” when this button is highlighted.
Select software version e.g. Washprog 3.x.bin , and select language file e.g. SvEn 3.x.spk.
Then press “Upload”. When the programming is ready a window “Upload ready” appears.
If you will upload again close the program window, and start over by pressing “Run from Flash”.
If a wrong language file is selected or the software don’t fit the machine-type, there will be an error
message.
Update EEprom with Granule programs and wash programs, by write the right values and press
“Update”.
Updating Service phone number, by write the number and press “Save”.
After troubleshooting and updateing (not uploading), you have to press “Run from Machine” to put
the machine in the ordinary mode again.
To end Flashloader press”X” in upper right corner.
To Next Page
Loading...
