GRAPHTEC CE LITE-50 - Data Creation and Cutting Precautions

2-11
Chapter 2 Basic Operations
2.6 Precautions when Creating Data
Notes regarding the Cutting Origin Position
The position of the cutting origin will vary depending on the settings for "Cutting Area". Create cutting data in
UHIHUHQFHWRWKHIROORZLQJ
Tilt correction: Enabled
Margin: Normal/Expanded
Tilt correction: Disabled
Margin: Normal
Tilt correction: Disabled
Margin: Expanded
7KHFXWWLQJRULJLQZLOODOZD\V
EHQHDUWKHYHUWH[RIWKHPHGLDHGJH
regardless of the state in which the
PDUJLQKDVEHHQVHW
Media Transport
Direction
X
Y
Cutting Origin

$VWKHDUHDEHWZHHQWKHPHGLDHGJH
DSSUR[LPDWHO\PPLQZDUGIURPWKH
HGJHLVRXWVLGHRIWKHFXWWLQJDUHD
WKHPHGLDZLOOQRWEHFXWLQWKLVDUHD
HYHQLIFXWWLQJGDWDH[LVWV
7KHFXWWLQJRULJLQZLOOEHWKH
YHUWH[RIWKHHIIHFWLYHFXWWLQJDUHD
7KHSRLQWDSSUR[LPDWHO\PPLQZDUG
IURPWKHIURQWHGJHDQGDSSUR[LPDWHO\
PPIURPWKHOHIWHGJH
Cutting
Origin
Approx. 5 mm
Approx.
10 mm
Media Transport Direction
X
Y
7KHFXWWLQJRULJLQZLOOEHWKH
YHUWH[RIWKHHIIHFWLYHFXWWLQJDUHD
7KHSRLQWDSSUR[LPDWHO\PPLQZDUG
from the front edge and the left edge.
Cutting
Origin
Approx. 5 mm
Approx. 5 mm
Media Transport Direction
X
Y

)RULQIRUPDWLRQRQWKHFXWWLQJRULJLQZKHQVFDQQLQJUHJLVWUDWLRQPDUNVUHIHUWR3ULQWLQJ&XWWLQJXSRQ
6FDQQLQJ5HJLVWUDWLRQ0DUNV

)RULQIRUPDWLRQRQKRZWRFKDQJHWKHFXWWLQJRULJLQUHIHUWR&XWWLQJXSRQ6SHFLI\LQJ&XWWLQJ3RVLWLRQV

)RULQIRUPDWLRQRQKRZWRFKDQJHWKHWLOWFRUUHFWLRQUHIHUWR6LPSOH3ULQWLQJ&XWWLQJ

)RULQIRUPDWLRQRQKRZWRFKDQJHWKHPDUJLQVHWWLQJVUHIHUWR([SDQGLQJWKH&XWWLQJ$UHD