GRAPHTEC CE LITE-50 - Page 34

2-12
Chapter 2 Basic Operations
Notes regarding the Cutting Area
The cutting area will vary depending on the media and the settings for "Cutting Area". Create cutting data in
UHIHUHQFHWRWKHIROORZLQJ
Media: Sheet media
Tilt correction:
Enabled/Disabled , Margin: Normal
Media: Sheet media
Tilt correction: Enabled/Disabled , Margin: Expanded
)URQW(GJHPP/HIW5LJKWPP5HDU(GJHPP
X
Y
10mm10mm
5mm
30mm
Cutting Area
Media Transport Direction
)URQW(GJHPP/HIW5LJKWPP5HDU(GJHPP
X
Y
5mm5mm
5mm
30mm
Cutting Area
Media Transport Direction
Media: Carrier sheet
Margin: Normal/Expanded
)URQW(GJHPP/HIW5LJKWPP5HDU(GJHPP
Media Transport Direction
X
Y
5mm5mm
5mm
5mm
Cutting Area

)RULQIRUPDWLRQRQKRZWRFKDQJHWKHPDUJLQVHWWLQJVUHIHUWR([SDQGLQJWKH&utting Area".

)RUPRUHLQIRUPDWLRQRQWKHFDUULHUVKHHWUHIHUWR&XWWLQJXVLQJWKH&DUULHU6KHHW
www.delinit.by