GRAPHTEC CE LITE-50 - Page 51

3-15
Chapter 3 Cutting along Printed Data
Graphtec Studio
[1] Creating the registration marks
Margin
X
Y
Media Transport Direction
1. )URPWKH5HJLVWUDWLRQ0DUNVWDELQ*UDSKWHF6WXGLRFUHDWHUHJLVWUDWLRQ
marks over the design.
$PDUJLQLVUHTXLUHGDWWKHHGJHRIWKHPHGLDZKHQFUHDWLQJWKH
registration marks. As the printing position may vary depending on the
SULQWHUXVHGWRSULQWWKHGHVLJQLWLVUHFRPPHQGHGWKDWDIHZH[WUD
PLOOLPHWHUVEHDOORZHGIRUWKHPDUJLQ
2. 6SHFLI\WKHUHJLVWUDWLRQPDUNSDWWHUQOHQJWKOLQHWKLFNQHVVDQG
arrangement positions.
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
3. 5HJLVWUDWLRQPDUNVZLOOEHFUHDWHGRYHUWKHGHVLJQ
[2] Creating data for printing & cutting
Cutting Data
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. &UHDWHSULQWLQJGDWDDQGFXWWLQJGDWDIRUSULQWLQJFXWWLQJ
Create the cutting data upon specifying a color that is not
used in the printing data.
www.delinit.by