GRAPHTEC CE LITE-50 - Page 52

3-16
Chapter 3 Cutting along Printed Data
[3] Printing the created data
1. Print the created data.
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.

Set the enlargement/reduction scale to 100%.

Set the printing position (center / bottom left, etc.) such that the relative positioning of the position of
the created document and the printed results are the same.
[4] Cutting the printed media
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Load the printed media onto CE LITE-50.
5HIHUWR/RDGLQJ6KHHW0HGLD
2. 2SHQWKH&RQÀJXUH&XW-RESDQHO
)URP$SSO\&RQGLWLRQVVHOHFW%\&RORUDQGVHOHFWWKHFRORUWRFXW
along.
3. 2SHQWKH3DJHSDQHO
,QRUGHUWRPDWFKWKHRULHQWDWLRQLQZKLFKWKHPHGLDKDVEHHQORDGHG
VHW527$7(WR
4. 2SHQWKH&XWWHUVSDQHO
5. 0RYHWKHWRROWRWKHXSSHUOHIWUHJLVWUDWLRQPDUNLQGLFDWHG
LQUHG
Move tool
here
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
6. &OLFNWKH6HQWWR&XWWHU
6FDQQLQJRIWKHUHJLVWUDWLRQPDUNVZLOOEHJLQDQGRQFHDOO
RIWKHUHJLVWUDWLRQPDUNVKDYHEHHQVFDQQHGWKHFXWWLQJZLOO
EHJLQ