GRAPHTEC CE LITE-50 - Page 84

5-6
Chapter 5 Detailed Settings
Setting the Blade Tip Orientation Initialization Position
3ODFHWKHEODGHDJDLQVWWKHPHGLDHLWKHULPPHGLDWHO\DIWHUWXUQLQJWKHSRZHU21RUSULRUWRFXWWLQJDIWHUVHWWLQJ
WKHSHQFRQGLWLRQVDQGDGMXVWWKHRULHQWDWLRQRIWKHEODGHWLS
$VWKLVRSHUDWLRQLQYROYHVSXWWLQJWKHEODGHRQWKHPHGLDVHWWKHSRVLWLRQDWZKLFKWKHEODGHWLSRULHQWDWLRQLV
initialized so that the initialization is performed at a position that will not scratch the cut.
OUTSIDE: 7KHEODGHWLSRULHQWDWLRQLQLWLDOL]DWLRQZLOOEHSHUIRUPHGDWDSRVLWLRQWKDWLVRXWVLGHRIWKHFXWWLQJ
area.
2mm BELOW: 7KHEODGHWLSRULHQWDWLRQLQLWLDOL]DWLRQZLOOEHSHUIRUPHGDWDSRVLWLRQWKDWLVPPGRZQZDUGV
IURPWKHFXWVWDUWLQJSRVLWLRQPPWRZDUGVWKHHGJHLQWKHPHGLDWUDQVSRUWGLUHFWLRQ
Cutting Area
Blade Tip Orientation
Initialization Position
Blade Tip Orientation
Initialization Position
OUTSIDE 2mm BELOW
2 mm
Cutting Origin
(Cut Starting
Position)
X
Y
X
Y
Media Transport Direction
1. )URPWKH0(18VFUHHQRSHQWKH722/
VFUHHQDQGSURFHHGWRWKH722/
screen.
2. 6HOHFW2876,'(RUPP%(/2:IRU
WKH,1,7,$/%/$'(